2017 Latest Maxisys MS908 Pro for ECU J2534 Programming

2017 Latest Maxisys MS908 Pro for ECU J2534 Programming


It’s an instruction on how to do ECU reflashing/Programming/Coding with Autel Maxisys pro MS908P tablet and J2534 ECU Programming device.

Note: so far, Autel MaxiSys MS908 PRO is th eonly full diagnostic scanner supporting online ECU Programming,

Step1-Connection issues:
Connect the car to a stable voltage supply
make sure the battery clamps are properly fixed
fully charge Autel MS908P tablet

Step2-connect to network
connect maxisys pro to the internet
make sure the network connection is stable to ensure a successful ECU programming
Both wired&wireless connection is ok, using ethernet cable
Check the connection status icon to confirm the internet connection is successful

Step3-Connection to J2534 ECU Programmer
Connect maxiflash J2534 ECU Programming device to MS908P using USB cable, Tighten the screws
Step4-Connection to the Car

Connect maxisys pro ms908p to the vehicle with OBDII cable
then, all connection complete

Part2-ECU Programming

Here goes the ECU Programming on BMW.

Select diagnostics n the main menu of maxisys pro ms908p

Select BMW

Turn ignition off…wait 10 seconds .. turn ignition on.

Tap ok and read out vehicle data